- #Dante virtual soundcard faq software
- #Dante virtual soundcard faq download
- #Dante virtual soundcard faq windows
Check if all the IP addresses are in a compatible range. In this case, make sure the firmware of Dante-MY16-AUD is v3.3.
#Dante virtual soundcard faq software
Check if some other consoles or software are already controlling the devices. Sí Dante Controller can set up audio routing between them and the console can remotely control the headamps of Rio, if Dante-MY16-AUD cards are inserted into the console and Rio units are set to AD8HR mode. Test with a different switch, or disable IGMP Snooping if you know how. In some rare cases (depending on switch type and device firmware versions) this can block the control data while allowing audio.
Check if the network switch is using a feature called “IGMP Snooping”. Installation of the Dante Virtual Soundcard is optional if you intend to connect. The IP address for MIXER CONTROL must be in a different subnet (number range) to the IP address for DEVICE CONTROL. To view the FAQ on connecting Nucleus2 to the internet / Dante. Check the Device ID begins with “Y0**”, where ** is a hexadecimal number between 01 and FF. Check the device firmware is up to date (v4.1 or newer for CL/QL, v1.7.34 or newer for ULXD4, v1.1.15 or newer for QLXD4, 1.16.11 or newer for AXT400). Check the IP address used by the Shure receivers: DEVICE UTILITIES->NETWORK->SHURE CONTROL->NETWORK.
If you are integrating this system onto an enterprise network, you should. accept a variety of I/O expansion cards AES67, analog, MADI, even DANTE. NOTE: The Audinate (i.e., Dante) implementation of AES67 only uses multicast flows. If audio is working well but the console is still unable to control the Shure receivers: Multi-layer operation using virtual faders gives operating access to many. Allows non Dante audio hardware connected to a computer to become I/O on a Dante network.Please refer to the respective video or documentation guide for the setup.Makes a computer an audio source and/or destination on the Dante network.Used to establish routing between devices.You can then choose up to 32 ch’s using the mixer sound card.
#Dante virtual soundcard faq windows
For support on other equipment within a Dante network, please contact that manufacturer.ĭo not contact Audinate for hardware support. The windows native version restricts ch count by a lot. Note that because Dante Virtual Soundcard is software-based, there is significant latency in the audio you hear from the network-at least 40ms. Audinate publishes and maintains authoritative resources that Renkus-Heinz recommends for the best and most up to date information.įor technical and operational support of your Renkus-Heinz loudspeakers, please contact Renkus-Heinz. Audinates Dante Virtual Soundcard is a powerful tool which enables your computer to receive and transmit audio on a Dante network. Net I/O Stageboxes, Dante Virtual Soundcard, Third party Dante devices) Connectivity Network: Console Connectivity Network SOLSA in Remote mode (if used) A tablet running TaCo (if used) Another SSL Live console in Remote mode (if used) Each network should have its own subnet. Dante Virtual Soundcard delivers the legendary audio quality that has made Dante the leading choice for audio networking by sound engineers, manufacturers and installers the world over. For example, network switch selection and configuration. Other Dante devices Secondary connection (e.g. While Dante simplifies connections and communication, there are some considerations to be aware of for a successful setup.
Renkus-Heinz Dante enabled loudspeakers are one element of a networked audio system that may be comprised of products from many manufacturers.
#Dante virtual soundcard faq download
Renkus-Heinz loudspeakers with integrated Dante connectivity require RHAON II, available for download here.